How to Install Roll Roofing

Are you looking to install roofing? Feeling let down by the expenses of shingle materials and the additional cost to the contractor or the workers? Well, you might need to explore more affordable choices for roofing. Roll roofing is an inexpensive option that you can find at a good roofing supply company, like Preferred Roofing, that can save you time and money.


What Is Roll Roofing?

Roll roofing (MSR) is a mineral surfaced asphalt oil-based material accessible in 100 square-foot rolls. It weighs around 75 pounds for each roll. You can source it from practically any home improvement outlet, tool shop, or online store. Even though roll roofing is similar to asphalt-topped shingles, it is significantly less expensive and less stiff.


Roll Roofing Installation


Tools and Materials Needed

To install roll roofing, here are the tools and materials you need:

• Hammer

• A measuring tape

• Carpenter’s square

• Broom

• The utility knife

• Tin shears

• Chalk-line

• Flashing

• Primer

• Roll roofing

• Nails for flashing and sheathing

• Roofing cement


Procedure


Mark a chalk line for the primary layer

Using a measuring tape, measure 35 inches (89 cm) up from the lower part of the rooftop and mark with chalk. 35 inches (89 cm) is the default measurement used by most material experts.


Apply roofing cement over the roof

Spread the cement along the edges of the rooftop, with a layer about 3.2–6.4 mm thick.


Cut the roofing material to the correct size

Lay the roofing material down, cut precisely over the marked chalk line, and extend from 1 side of the rooftop to the next.


Place the first layer of roofing material on the rooftop

First, place the roofing material down and stretch it to straighten out any wrinkles. Push the folded material down into the wet concrete to adhere it to the rooftop.


Hammer nails into the roofing material

Use a hammer and 1-inch (2.5 cm) nails to drive the nails in every 10 inches (25 cm) across the rooftop. Ensure that you hammer the nails flush into the rooftop - don’t leave the nails standing up over the layer.


Measure and mark another chalk line over the primary layer

Use your measuring tape again to mark 32 inches (81 cm) over the primary layer.


Apply roofing cement and secure the second layer to the rooftop

Get a scoop of cement and apply it on the rooftop underneath the subsequent chalk line. When the cement is spread across the rooftop, it’s time to put the second layer down. In the same manner as above, place the initial 6 inches (15 cm) of the second layer on top of the main layer.


Trim the excess and seal the edges

With a razor blade, trim the overhanging material to eliminate any extra roofing material. At the point when you’re done trimming the extras, test the edges to check whether you can lift them. Apply more adhesive where needed and seal the edges down completely.


Clean the roll roofing before you finish

Have one more look at the roofing and clear away dirt, debris, and leftover materials.


That’s a brief overview of how to install roll roofing. If you need more advice or are looking for a good roofing supply company, look no further than Preferred Roofing Supply. We’ve got the preferred brands at the preferred prices, and a team of experts ready to help you find what you need for any project. Check out our External link opens in new tab or windowwebsite or call us at 678-395-6800.